Skip to main content

Posts

Showing posts from September, 2021

In 2023, is it suitable to use miners to mine or buy coins?

In 2023, is it suitable to use miners to mine or buy coins? In recent years, with the increasing popularity of blockchain technology and the rapid development of digital currency, more and more people have joined the team of mining and buying of coins. In 2023, for most people, choosing to use a miner to mine or buy coins will be a critical decision. Advantages and disadvantages of miners High power consumption, high cost, and high technical requirements are the salient features of miners' mining. But at the same time, miners also have a stable income from mining and have the advantage of controlling the speed of block verification. Here are a few viable Bitcoin miners and their profitability in 2023. Antminer S19 Pro is a miner produced by Bitmain , which is very popular in the market. It is equipped with 114 BM1398 ASIC chips , which can achieve a faster and more stable mining experience. It is estimated that the average daily income of this type of miner in 2023 will exceed 120

How to inspect and repair antminer hash board inductors?

How to inspect and repair antminer hash board inductors? The magnetic rod inductors or magnetic loop inductors in the circuit board are mainly used in various power supply circuits. The magnetic rod/magnetic ring inductor can be measured with a digital multimeter or a pointer multimeter. For accurate measurement, the inductor can be measured with an open circuit. Use a digital multimeter to detect the inductor in the circuit board: (1)  First, disconnect the power supply of the circuit board, and then observe the magnetic bar inductor to be tested to see if the inductor is damaged, whether it is burnt, soldered, or the coil is deformed. If there is, the inductor has been damaged. The figure below shows a magnetic bar inductor to be tested. (2)  If the appearance of the magnetic rod inductor to be tested is not damaged, solder the magnetic toroidal inductor to be tested from the circuit board with an electric soldering iron, and clean the pins at both ends of the magnetic toroidal induc